BOT-LED-3000P white light parallel light source is a series of light inspection machine light sources developed and launched by our company. The light source output is equipped with a collimating beam expander. This light source has the advantages of high beam quality, high electro-optical efficiency, high stability, small size, maintenance-free, and easy operation. It is suitable for medical equipment, testing equipment, optoelectronic materials research institutes, universities and other scientific research units.
Main Technical Features
· Output power 0-50000mW (maximum) continuously adjustable
· Continuous output mode
· Highly integrated electricity, light and control, plug in and produce light
· High stability, output power fluctuation <5% at full load
· Collimated light source output, adjustable focus point
· Easy to operate and maintenance-free
The Main Technical Parameters
Model# | BOT-LED-3000P | Unit |
Central Wavelength | White Light | nm |
Spectral Line Width |
| nm |
Output Power | 0—50000 | mW |
Operating Mode | CW |
|
Beam Diameter | 25 | mm |
Operating Voltage | 220 | VAC |
Total Power Consumption | 0-5 | W |
Cooling Method | Natural Cooling |
|
Power Stability | <5 | % |
Size | Ф30×125mm | mm3 |
Weight | 1.5 | kg |
Instructions for Use:
1. The light source driving power supply is two-channel, and it can carry two light sources at the same time. When using a single channel, it can be used at will.
2. The brightness of the light source can be adjusted. The adjustment knob is at the position corresponding to the front panel and the connected light source. It will become larger clockwise and smaller in the opposite direction. For general use, you can adjust it to the maximum.
3. The optimal use distance of the light source is 12-15cm, and the light spot is 25mm. If the use conditions are not met at the scene, you can adjust the two front lenses and fix them with screws after adjustment.
Precautions:
1. Check whether there is any abnormality in the appearance of the light source before use.
2. Check whether the potentiometer is in a low power state. The low power starting performance is reliable and safe.
3. This light source is powered by AC220V. Please check whether the power supply is normal before use.
4. Keep the light source away from the water source as much as possible when using it. Once the lens becomes foggy, the light output power will be affected. Please be careful when using it.
5. The power of this light source is adjustable. When using the adjusting resistor, please move it slowly and smoothly. Do not move it too high or too low, as it may cause damage. Please observe the current when adjusting. During normal and continuous use, the clockwise needle of the potentiometer is adjusted to high power output, otherwise it is low power output. If it cannot be adjusted, it will be the maximum or minimum value.
